Wall Controller Configuration - Bose ControlSpace AMS8 Safety Instructions & Installation Manual

3. System Installation

3.3 Wall Controller configuration

10
2 3
Before configuring the ControlSpace
this is normally done the first time the wall controller is connected to the system rack. A few seconds after
the wall controller has been connected to the system rack, the Firmware version is displayed on the LCD
screen, followed by "Select WC..". Use the channel buttons to select the appropriate number and confirm
this choice by pressing the volume down (-) button. If multiple wall controllers need to be used to control
the same room, one should select the same number on these wall controllers as well. In a situation like
this, all wall controllers need to be connected to the same rack frame.
If a wall controller already has a number then it can be altered as follows:
1. Switch the wall controller off (press the channel down (-) button as many times as needed
until the wall controller is switched off)
2. Press and hold the channel down (-) button
3. Press the volume up (+) and down (-) buttons at the same time (After the LCD screen has
displayed the Firmware version it displays the actual number, e.g. "WC2").
4. Now you can use the channel buttons to select the appropriate number and confirm this
choice by pressing the volume down(-) button in the same way as before.
If the system consists of two or more ControlSpace
For the first rack numbers 1..8 are used for output channels 1..8, for the second rack output channels 9..16
up to the tenth rack for outputs 73..80.
Changing room settings using the wall controller
For the room where the wall controller is installed one can adjust the audio settings using the hidden
menu in the wall controller. Follow the procedure below to enter this menu:
1. Switch the wall controller off (press the channel down (-) button as many times
as needed until the wall controller is switched off)
2. Press and hold the volume down (-) button
3. Press the channel up (+) and down (-) buttons at the same time
In the hidden menu the following functions can be set or altered:
a. default channel
d. dynamic EQ
g. paging volume level
The channel buttons allow you to scroll through the menu items whilst the volume buttons allow you to
change the settings for the selected item.
To leave the hidden menu, press the channel up (+) and down (-) button at the same time.
1
1. LCD SCREEN
2. VOLUME KEYS
3. CHANNEL KEYS
™ AMS-8, one needs to select a number for each wall controller (1..8),
™ AMS-8 racks, all racks use numbers (1..8).
b. bass level
e. Bose speaker EQ
h. delay
c. treble level
f. maximum volume level
i. default volume level