Wall Controller Configuration - Bose ControlSpace AMS-8 Installation Manual

3. System Installation

3.3 Wall Controller configuration

10
2 3
Before configuring the ControlSpace
this is normally done the first time the wall controller is connected to the system rack.
A few seconds after the wall controller has been connected to the system rack, "Select WC.." is displayed
on the LCD screen. Use the channel buttons to select the appropriate number and confirm this choice by
pressing the volume down (-) button.
If a wall controller already has a number then it can be altered as follows:
1. Switch the wall controller off (press the channel down (-) button as many times as needed
until the wall controller is switched off)
2. Press and hold the channel down (-) button
3. Press the volume up (+) and down (-) buttons at the same time (The LCD screen now
displays the actual number, eg "WC2").
Now you can use the channel buttons to select the appropriate number and confirm this choice by pressing
the volume down(-) button in the same way as before.
If the system consists of two ControlSpace
numbers 1..8 are used for output channels 1..8 and for the second rack output channels 9..16.
Changing room settings using the wall controller
For the room where the wall controller is installed one can adjust the audio settings using the hidden
menu in the wall controller. Follow the procedure below to enter this menu:
1. Switch the wall controller off (press the channel down (-) button as many times as needed
until the wall controller is switched off)
2. Press and hold the volume down (-) button
3. Press the channel up (+) and down (-) buttons at the same time
In the hidden menu the following functions can be set or altered:
a. default channel
d. dynamic EQ
g. paging volume level
The channel buttons allow you to scroll through the menu items whilst the volume buttons allow you to
change the settings for the selected item.
To leave the hidden menu, press the channel up (+) and down (-) button at the same time.
1
1. LCD SCREEN
2. VOLUME KEYS
3. CHANNEL KEYS
AMS-8, one needs to select a number for each wall controller (1..8),
™
™ AMS-8 racks, both use numbers (1..8). For the first rack
b. bass level
e. EQ filter type
h. delay
c. treble level
f. maximum volume level
i. default volume level