Advertisement
Your Curtis G3/Gold Cup Series is factory preset for optimum performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays
CURTIS
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached
takes approximately 20 minutes to reach the set point temperature.
CURTIS
Control will display
Ready to Brew
Programming the Universal Control Module (UCM)
Turn off the control panel by pressing the ON/OFF button. Press and hold the bottom/right coffee brew button (#4 in illustration) and then press and release the ON/OFF button.
Continue holding the bottom-right brew button. The screen will display
the buttons illustrated below. The default code set at the factory is 1-2-3-4.
After the 4-digit code is entered,
<
1
PROGRAM MENUS COMBO BREWER
From Program Menus press ►. The display will show the next feature Coffee Recipes.
Program Menus
Coffee Recipes (factory set to Gourmet STD)
Press to select. If selected, press ◄ or ► to choose a coffee recipe: Gourmet STD, Light Roast, Dark Roast, High Yield,
Coffee Recipes
Filter Pack or Decaf. Press to select the desired recipe.
Non-Brew Program
Press to select ◄ or ► to pass by these options and continue to the next group. The selections for Non-Brew Program
Non-Brew Program
are listed below.
Temperature (factory set to 204ºF)
Press to select. Then press ◄ or ► to move to the desired temperature, then to set and exit. The temperature is
Temperature
programmable from 170ºF to 208ºF in 2-degree increments.
Energy Save Mode (factory set to OFF)
Press to select. Then press ◄ or ► to choose ON, OFF or ON 140ºF, then to set and exit. When ON, the brewer will
automatically shut off 4 hours after the last brew. When the feature is OFF, the brewer does not utilize the energy saving mode.
Energy Save Mode
In the ON 140ºF position, the temperature lowers to 140ºF, if the unit has not brewed in 4 hours. This feature will save energy by
maintaining a lower temperature in the tank in periods of non-operation.
Brew Count Odom
Brew Count Odom
Press to display total brew cycles. Press EX or Reset.
Brew Count Total
Brew Count Total
Press to select. This feature shows the total gallons and total brew cycles on the brewer. It cannot be reset.
4
. Press ON/OFF button and the screen will display
when temperature reaches the set point. The unit is now ready to brew.
Programming Mode
Program Menus
will be displayed. You can now enter the program menu features.
Select
>
2
3
<CBHVT>
CURTIS
Entering
Enter Code
, wait until
– – – –
All programming selections are performed with the
three center buttons. The symbols above and below the
buttons are:
◄ Scroll left (button 1)
Select or Enter to save new parameter (button 2)
► Scroll right (button 3)
4
. After three seconds,
CURTIS
Filling
CURTIS
will appear on the screen. It
Heating
is displayed. Enter the 4-digit access code, the code corresponds to
is displayed.
Advertisement
