Advertisement
HOT WATER FAUCET INSTALLATION
The hot water faucet is shipped loose and must be attached during the initial set-up of the brewer. To attach the hot water faucet,
you will need a ratchet type socket wrench with a 3/4" (approximately 2" deep) socket for nut removal and tightening.
Faucet Installation Instructions:
1. Disconnect power to the brewer.
2. Carefully remove the round plug from the faucet hole on the
left or right side panel. See diagram below.
3. Remove the screws that hold the front cover in place and
remove the cover.
4. Take the faucet and insert the shaft into the faucet hole.
5. From inside the brewer, slide the lock washer over the faucet
shank. Then, thread the nut onto the faucet shank.
2
Side panel
4
5
6. Hold the body of the faucet while tightening it with the
3/4" socket.
7. Locate the hot water tube that runs from the hot water
tank inside the brewer. It has a plug on the end of it.
8. Remove the plug from the hot water tube.
9. Slide the end of the hot water tube over the smooth
section of the faucet shank, inside the brewer.
10. Replace the front cover.
2
6
3
7
8
9
Advertisement
