Product Description; Assembly; Name Of Parts: (Fig. 1) - Black & Decker PW1200 Manual

8
English
Power cord connections should be kept dry and off
the ground.
– If the power cord is damaged, it must be
replaced by the manufacturer or his service
agent or similarly qualified person in order to
avoid a hazard.
All keep the machine on a stable and flat surface
during operation, handling, transportation and
storage. Sudden overturn of machine will cause
injury to body.
In the event of accident or breakdown, switch
off the machine immediately. (e.g. contact with
detergent: rinse with an abundance of clean water)
ATTENTION:
Through poor conditions of the electrical MAINS,
shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment
(eg. Blinking of a lamp). If the MAINS-IMPEDANCE
Zmax < 0.335 OHM, such disturbances are not
expected. (In case of need, you may contact your
local supply authority for further information.)
WARNING: ELECTRICAL SHOCK
HAZARD.
Improper connection of the equipment-
grounding conductor can result in a
risk of electrical shock. Check with a
qualified electrician or service person if
you are unsure if an outlet is properly
grounded. DO NOT modify the plug
provided with the appliance to fit an
outlet, have a proper outlet installed by
a qualified electrician.
MAINS POWER CONNECTION
T e h following should be observed when
connecting the high pressure washer to
the electric installation:
– The electric installation shall be made by a
certified electrician and comply with IEC-364.
– It is recommended that the electric supply to
this appliance should include either a residual
current device that will interrupt the supply if
the leakage current to earth exceeds 30 mA for
30 ms.
IMPORTANT! Only Use Water Without Any
Impurities If There Is A Risk Of Running Sands
In The Inlet Water (I.E. From Your Own Well), An
Additional Filter Should Be Mounted.
SAFETY DEVICES
– The unloader valve can reduce pressure if it
exceeds pre-set values. The spray gun features
a locking device. When the pawl is activated,
the spray gun cannot be operated.
THERMAL SENSOR:
A thermal sensor protects the motor against over-
loading. The machine will restart after a few minutes
when the thermal sensor has cooled.

4. NAME OF PARTS: (FIG. 1)

1. On/Off switch
2. Water outlet
3. Water inlet
4. Warning label
5. Rating label
6.
Detergent bottle (PW1200 ONLY)
7. Mid lance

5. PRODUCT DESCRIPTION

PURPOSE
• The high pressure cleaner is designed to clean
vehicles, machines, buildings, facades, etc. in
the private sector.
AREAS OF APPLICATION
• Never use the machine in potentially explosive
areas under any circumstances!
• The operating temperature must be between 0
and +40°C.
• The machine consists of an assembly with a
pump, which is encased in a shock absorbing
housing. For an optimal working position the
machine comes with a lance and a non-slip
handle grip, whose shape and configuration
comply with the applicable regulations.
• Do not cover or modify the lance or the spray
nozzles in any way.
• The high pressure cleaner is designed to be
used with cold or lukewarm (max. 40°C);
higher temperatures can damage the pump.
• Do not use water that is dirty, gritty or contains
any chemical products, as these could impair
operation and shorten the life of the machine.
• Accessories can be used to carry out work
with foam cleaners, sand spraying.

6. ASSEMBLY

• Position the washer as NEAR as possible to
the water supply.
8.High pressure hose
9. Spray gun
10. Trigger
11. Gun lock
12.Cord hook
13. Turbo lance
14. Power cord