Setting Camera Delay; Setting Camera State And Resolution - Ranger BN055 Instructions For Use Manual

Press SETUP to enter the setup mode, which starts
by flashing the word "DATE". Press UP or DOWN to
access the previous or next menu option, and OK to
adjust the current setting. Once you are satisfied with
the changes you have made press SETUP to accept
the changes and put the camera into sleep mode.
6.1 S
ettIng
Camera Delay specifies the amount of time in minutes
and seconds between successive PIR triggered
photos. This setting ranges from 1 second to 60
minutes 59 seconds. Default is 1 minute.
1. Enter setup mode as described on page 9. The
LCD will flash "DATE".
2. Press the UP or DOWN button until icon #6
"Camera delay" is blinking then press OK.
3. By default the LCD will display "0100", the first
two digits represent minutes and last two digits
represent seconds.
4. When the cursor flashes on minutes, press UP or
DOWN to change the value (from 00-60), press
OK to confirm.
5. The cursor will now be flashing seconds. Press
UP or DOWN to change the value (from 00-59)
and press OK to confirm.
6. Press SETUP to save and exit.
6.2 S
ettIng
Set the number of pictures the camera will take each
time the PIR detects movement. One still image, three
c d
aMera elay
c S
aMera tate and
p
hoto
- 9 -
r
eSolutIon