Turning On The Camera; Adjusting Pir Sensitivity; Testing The Camera Coverage Area - Ranger BN055 Instructions For Use Manual

7.2 t c
urn on the aMera
If the camera is off, turn it on and enter your four
digit password (the default is 0000), when the correct
password has been entered the camera automatically
enters sleep mode and will start taking photographs
or video after the delay time (see 6.1 Setting Camera
Delay on page 10).
7.3 a pIr S
djuStIng enSItIvIty
Adjust the PIR sensitivity range from 2 metres to
20 metres by using the PIR sensitivity adjustment
dial as shown in the parts identification diagram on
page 5. Setting the dial to a higher number increases
sensitivity for longer distances, and setting the dial
to a smaller number decreases sensitivity for shorter
distances. Note that actual distance can vary due to
environment temperature, object size etc.
7.4 t c c a
eStIng the aMera overage rea
After mounting the camera enter setup mode as
described on page 9. A red indicator light on the
front (the Working Indicator) will blink when you
have intruded the PIR coverage area. Adjust the
camera position as needed and repeat testing
until the desired coverage area is achieved.
- 14 -