Changing The Password; Display Number Of Images / Videos Stored - Ranger BN055 Instructions For Use Manual

Remember to reset the date and time whenever
you set the camera up.
▲ Remove batteries if the camera is to remain
unused for a long period of time.
6.4 c
hangIng the
The system will always require you to input a
password to activate the camera or to access setup.
The default password is "0000". The first time you turn
on the camera just press OK five times to go through
the security check.
1. Enter setup mode as described on page 9. The
LCD will flash "DATE".
2. Press UP or DOWN until #7 "PASSWORD" is
blinking, and press OK.
3. Press UP or DOWN to select 0 to 9 and press
OK to proceed through to the next digit.
4. When all four digits are set press SETUP to save
and exit.
▲ Note: If you forget the password, contact your
dealer with details of your purchase receipt and
they will help you to reset it.
6.5 d
ISplay nuMBer of IMageS
1. Enter setup mode as described on page 9. The
LCD will flash "DATE".
2. Press UP or DOWN until #8 "SD card" is blinking.
3. The LCD will display the total number of pictures
and videos stored on the SD card.
p
aSSword
- 12 -
/
vIdeoS Stored