Manual Amplitude Setting - cefar myo X2 User Manual

If you press AUTO too late, or want to start again for any reason, press and
hold the AUTO button for 2 seconds to start over.
9. The AUTO on the other channel starts flashing.

· If you only use one channel: Wait a few seconds and the AUTO stops flas-
hing.
· If you use both channels: Press the other channel's
the two channel use. The other channel's auto test starts. Repeat step 8 to
set the amplitude.
The amplitude is now optimized for you and the training program will start
after a few seconds. When the program is finished the timer flashes "00:00".
or can be used to increase or decrease stimulation amplitude at
any time until the stimulation feels pleasant, presumed that the key lock is
inactivated. If doing so, the Automatic Amplitude Setting is lost and the stimu-
AUTO AUTO
AUTO
lator goes to Manual Amplitude Setting.
S
P S
P

MANUAL AMPLITUDE SETTING

Prepare the equipment as described in Step-by-Step Use , step 1-6
7. Press to set the amplitude and start the stimulation.
8. Increase or decrease the amplitude using
comfortable level. Always increase the amplitude cautiously.
AUTO AUTO
P S
When the program is finished the amplitude automatically returns to 0, and
the timer flashes "00:00".
Note: Do not forget to set the amplitude for the Active Rest (in manual mode
only), see section Active Rest.
2526_CEFAR_MYO.ACTIV_X2__ENG_3-18 8
, to confirm
AUTO AUTO
S
P
AUTO
and until you reach a
AUTO AUTO
AUTO
P S
P
AUTO
S
2006-07-07 11:09:58