Table of Contents
Advertisement
8.3. Front Panel Power Button Active
Default Setting:
The front panel power button can be disabled if desired. Disable the button when the matrix switcher is
programmed to be on at all times or in jobs where turning off the matrix from the switcher can cause issues with
control.
9. FIRMWARE UPDATE
Binary™ may occasionally release new firmware for theB-120-HDMATRIX-8x8 to address new standards and
technology. It will never be necessary to perform an update to an existing, correctly functioning system, but during
installation or service, it is recommended to check the installed version to be sure it is the newest available.
For full update instructions, see the section titled Firmware Update in the Configuration Utility Manual. New
firmware, the Configuration Utility, and the Configuration Utility Manual are available for download on the
Support tab of the B-120-HDMATRIX-8x8 product page at www.SnapAV.com.
10. OPERATION AND CONTROL
During setup and testing, use the included IR remote to control the matrix switcher. After setup is complete, a
control method should have been setup and programmed as described in Section 6.7. Matrix Control Connections for
regular operation.
10.1. IR Remote
This section describes the correct button-push sequences to perform regular operations with the IR remote.
The ENTER key must be pressed within 10 seconds of the last command in order to be processed.
POWER
ON
1
1
2
3
4
5
7
8
ALL
ENTER
10+
5
4
6
STATUS
LEARN
DEFAULT
10
11
12
OFF
2
1
2
OUTPUT
3
7
3
INPUT
6
4
8
5
OUTPUT
9
6
9
7
OFF
8
9
CLEAR
10
13
11
12
13
FIGURE 7 : Remote Functions
Yes
Key
Function
ON
Power on the matrix switcher
OFF
Enter standby mode
Number Keys
Select a number
1-9
10+
Not used
ALL
Select all Inputs or Outputs
ENTER*
Enter to trigger the previous setting
OUTPUT
Begin Output selection
INPUT
Begin Input selection
OUTPUT OFF
Turn off/mute the selected Output
STATUS
Present EDID or Output status
LEARN
Learn EDID from one Output
DEFAULT
Begin embedded EDID selection
CLEAR
Clear the former IR operation
procedure which user just pressed
but has not yet applied by pressing
ENTER
14
Advertisement
Table of Contents
