Table of Contents
Advertisement
7.6. Viewing Input EDID Status
If there is a question about the EDID set for an input, the status of that input's EDID can be reviewed using the
included IR remote and watching the matrix switcher front panel display.
Example: View the EDID for Input 3.
1. Press STATUS
2. Press INPUT
3. Press Number Key (1-8) to select the desired
Input
4. Press ENTER
Notes about EDID Status
•
If the EDID was learned from an output, the exact EDID specifications will not be shown, but the output
number will be identified. Review the specifications of the display attached to the output to determine its
compatible resolutions.
•
If the second digit (the Input being queried) has a dot after it, then the first digit is the EDID number from the
Embedded EDID table.
•
If the second digit (the Input being queried) does not have a dot after it, the first digit is the output the EDID
was learned from (step 4 from example above).
8. ADVANCED SETUP USING THE CONFIGURATION UTILITY
There are several setup options available that can only be modified using the matrix switcher Configuration Utility.
These items are defaulted to the most common settings that should work in most installations.
The Configuration Utility and manual are available for download on the Support tab of the B-120-HDMATRIX-8x8
product page at www.SnapAV.com. Download and run the utility to gain access to these settings connecting to the
matrix and clicking Other Settings.
8.1. IR Front Panel IR Enable
Default Setting:
This setting controls the operation of the front panel IR receiver built into the B-120-HDMATRIX-8x8. This should
be disabled if using the SYSTEM IR IN port to control the matrix switcher via IR, or if the matrix switcher is missing
or receiving extra commands during use (stray IR interfering with the port).
8.2. Matrix Control from Room Enable
Default Setting:
The Matrix Control From Room Enable option allows Matrix Control IR commands to be sent from the room as if
a source were being controlled. Turn this option off if the matrix switcher is being controlled by any other method
than in-room IR.
Note: To use Matrix Control From Room, it is recommended to program a universal remote control with discrete
commands for matrix control to keep in each zone, rather than using the included IR remote or commands learned
from it. Go to the Support tab of the B-120-HDMATRIX-8x8 product page at www.SnapAV.com to see and
download the available IR codes and drivers for IR remote programming.
Display Readout (Example)
EDID 5 Assigned from
Embedded EDID Table
--
--
-3
5.3.
Yes
Yes
13
EDID Learned from
Output 4
--
--
-3
4.3
Advertisement
Table of Contents
