Viking E-20 Product Manual page 6

C. Replacement IP Board Kit (Model E-1600-53A-IP)
This is a board (PCB) only kit, no chassis is included. This kit can be used to convert any Viking E-10A or E-30 analog
phone to a VoIP version. The kit can also be used to replace a damaged IP board in the field. This kit comes in standard
and EWP version. The optional EWP version features foam rubber gaskets and boots, sealed connections, gel-filled
butt connectors, as well as urethane or thermal plastic potted circuit boards, see DOD# 859 for more information.
(2) 0.156
diameter
type 2
mounting
holes
Optional 2 Amp Relay
Output Contacts Connector
Connect to doorstrike,
mag lock, gate controller, etc.
Gray (N.C.)
Blue (COM)
Yellow (N.O.)
** Note: These two red wires are only
used on units with an Info button. When
installing on a single button unit, cut off
these two red wires and discard.
How to Replace Analog E-10A, E-10A-EWP or E-30-EWP Circuit Boards:
Step 1. Cut wires from J1 (10 pin connector) and J2 (2 pin connector).
Step 2. Remove the two #6 phillips screws fastening the circuit board.
Step 3. Cut off any stripped wire ends from the replacement cable.
Using the supplied gel-filled butt connectors, connect corresponding wires from replacement cable to the previously cut
Step 4.
wires from the LED, Call switch, Speaker and Microphone. See FIGURE 1 above for wire color and polarity.
Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a maximum in-
sulation of 0.082 inches. Cut off stripped wire ends before terminating.
6
3.50 (3.58 EWP)
3.20
8 1 10 1
0.15 (0.19 EWP)
Shipping Weight: .45 kg (1 lb)
Connections: (1) RJ45 10/100 Base-T, (3)
optional gel-filled butt connectors, (10) addi-
tional gel-filled butt connectors included with
2.0
EWP version only.
(2.04
EWP)
2.63
1.5
(2.71
EWP)
0.63
(0.67
Replacement Cable Assembly
EWP
Connector and Wires
from Existing Standard
E-30 Analog
Entry Phone
Black
Red
Black
Black
Red**
- OR -
Red**
White
White
Black
Red
E-1600-53A-IP Board Specifications
FIGURE 1
(included )
Replacement connectors, wires and
butt connectors for use when replacing
E-10A/EWP or E-30-EWP circuit boards.
- Black
LED
+ Red
Black
Call Switch
Black
Red**
Info Switch
Red**
White
Speaker
White
- Black
Mic
+ Red
(not used)