Viking E-20 Product Manual page 5

IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC
outlet and the telephone line. It is recommended that a surge protector be installed to protect against such surges.
A. Mounting the E-10-IP, E-10-IP-EWP, E-30-IP and E-30-IP-EWP
The E-10-IP and E-30-IP are designed to be flush mounted to the included 4" x 4" x 2" deep plastic rough in box or sur-
face mounted using an optional Viking model VE-5x5. Note: The E-10-IP and E-30-IP will NOT mount to a standard
double gang box. The plastic rough in box (part # 259576) may be purchased separately. Go to www.vikingelectron-
ics.com and click on "Spare Parts".
Front View of Plastic
Rough-In Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
5.22"
5.14"
Front View of Optional
2.25"
VE-5x5 (not included)
B. Mounting the E-20-IP and E-20-IP-EWP
The E-20-IP and E-20-IP-EWP are designed to be surface mounted to a single gang box (not included), a standard 4"
x 4" electrical junction box (not included), or directly to a wall or flat sided post. Caution: For rough surfaces (ie: brick,
stucco, etc.) additional caulking may be required.
3.40"
1.55"
3.40"
2.35"
Installation and Specifications
4.0"
3.25"
(1) .74" dia
Condensation
Drain Hole
Rear View of VE-5x5 (not included)
Front view of the
E-20-IP/E-20-IP-EWP
3.30"
VIKING
©
To open the speaker box, remove the
two separate screws from the cover.
2.1"
*
1/8" thick foam
gasket (included)
5.0"
Typical
Push to Call Button
(4) 6-32 X 3/4" stainless steel, flat
head, hexdrive, screws (included)
Condensation Drain Hole
(4) 0.38" diameter (for gooseneck mounting)
(4) 0.2 x 0.43 slots for double gang box
(2) 0.2 x 0.43 slots for single gang box
3.0" 3.3"
3.0"
Back Panel of the
E-20-IP/E-20-IP-EWP
UP
Call
Mount back panel to a wall, a single
gang box or a 4"x4" junction box with
the arrow pointing up. Note: For
outdoor applications apply a bead of
caulk between back panel and wall.
* Note: Peel off paper liner and adhere
gasket to the back of the faceplate, center-
ing it over the four corner mounting holes.
Caution: For rough surfaces
(ie: brick, stucco, etc.) additional
caulking may be required.
The optional VE-5x5 Surface Mount Box is designed to be
surface mounted to a single gang box, double gang box
or VE-GNP gooseneck pedestal (shown right). For more
information on the VE-5x5 and VE-GNP, see DOD# 424.
Side view of the
E-20-IP/E-20-IP-EWP
Attach the cover to the
base with the two included
screws as shown.
5