Torque Limiter; Indicator Lamp - Makita HR3200C Instruction Manual

For drilling in wood, metal or plastic materials, depress
the lock button and rotate the change lever so that the
pointer points to the
wood bit.
Hammering only
1
2
008539
For chipping, scaling or demolition operations, depress
the lock button and rotate the change lever so that the
pointer points to the
chisel, scaling chisel, etc.
CAUTION:
Do not rotate the change lever when the tool is
•
running under load. The tool will be damaged.
To avoid rapid wear on the mode change
•
mechanism, be sure that the change lever is
always positively located in one of the
action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the
output shaft. When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch off
•
the tool immediately. This will help prevent
premature wear of the tool.

Indicator lamp

1
2
008541
The green power-ON indicator lamp lights up when the
tool is plugged. If the indicator lamp does not light up,
the mains cord or the controller may be defective. The
indicator lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn out,
symbol. Use a twist drill bit or
1. Pointer
2. Change lever
3. Lock button
3
symbol. Use a bull point, cold
1. Power-ON
indicator lamp
(green)
2. Service indicator
lamp (red)
or the controller, the motor or the ON/OFF switch may be
defective.
The red service indicator lamp lights up when the carbon
brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Side grip
008542
three
CAUTION:
Always use the side grip to ensure operating safety
•
when drilling in concrete, masonry, etc.
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the side grip
by turning it counterclockwise, swing it to the desired
position and then tighten it by turning clockwise.
Installing or removing the bit
1
003150
Clean the bit shank and apply bit grease before installing
the bit.
Insert the bit into the tool. Turn the bit and push it in until
it engages.
6
1. Side grip
1
1. Bit shank
2. Bit grease
2