LED Number
LED 1
LED 2
LED 3
LED 4
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Set the Power Supply 4.0V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1
Table 11-4 LED Description
Name
Power
TA
Indicate charging state of the phone battery
UART
Indicate data transfer state through the UART port
MON
Indicate data transfer state through the MON port
- 103 -
Description
Power is provided for Test Jig
st
ON state
9. Calibration