Major Operating Components And Their Functions; Front View; Rear View - Panasonic WV-PS154 Operating Instructions Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

Front View

Power
ON
PROTECTOR
OFF
q

Rear View

q Power On/Off Switch (POWER ON/OFF)
This switch is used to turn the camera drive unit and
connected cameras on and off. The indicator lights up
when the camera drive unit is switched on.
When turns this switch off, the power supply does not
interrupt. In such a case, disconnect the AC cord or
turn the circuit breaker off.
Note: To prevent accidental interruption of power sup-
ply to the camera drive unit, cover the power switch
with the supplied switch protector as shown below.
w Camera Input Connectors (CAMERA IN 1, 2, 3, 4)
These connectors receive color or B/W composite video
signals from the cameras. They also supply DC power
and vertical drive pulses for synchronizing signals to
the cameras and receive video and audio signals from
the cameras.
e Video Output Connectors (VIDEO OUT 1, 2, 3, 4)
Video signals from the cameras are output from these
connectors for input to outboard devices.
r Audio Output Connectors (AUDIO OUT 1, 2, 3, 4)
Audio signals from the cameras are output from these
connectors for input to the outboard devices (if an
applicable camera is connected).
4
SWITCH
POWER LED WILL FLASH
IF COOLING FAN MALFUNCTIONS
w
4 3 2 1
CAMERA IN
e t
2 1
4 3 2 1
4 3
(4V[p-p]75Ω)
VIDEO OUT AUDIO OUT
r y
t VD/SYNC Input Connector (VD/SYNC IN)
The VD (Vertical Drive) pulse or VS (Video Sync) signal
is supplied to this connector for synchronizing the sys-
tem.
y VD/SYNC Output Connector (VD/SYNC OUT)
The VD (Vertical Drive) pulse or VS (Video Sync) signal
is output from this connector for synchronizing other
system components.
Note: Be sure that the specified camera and camera
input1 are connected correctly and firmly. The syn-
chronizing signal is not supplied if this connection is
faulty.
u Cooling Fan
This unit prevents the temperature of the camera drive
unit from rising
Caution:
Do not block the ventilation opening or slots on the
cover to prevent the temperature of the camera drive
unit from rising. The power indicator blinks to indicate
an unusual temperature rise. Do take immediate
action when the power indicator blinks. Turn the
power off and refer servicing to qualified service per-
sonnel.
The cooling fan inside the camera drive unit is subject
to wear and need to be replaced periodically.
i AC Cord
o Signal Ground Terminal (SIGNAL GND)
Camera Drive Unit WV-PS
VD/SYNC
IN
VD/SYNC
OUT
u i
o
SIGNAL
GND