Table of Contents
Advertisement
Step 9.
To install the new hard disk drive:
a.
Attach the bracket pieces to the new hard disk drive, and secure them with the 4 screws.
b.
Slide the new hard disk drive into the hard disk drive bay.
c.
Secure the new hard disk drive to the rear cover with the 6 screws.
d.
Connect the data and power cables to the new hard disk drive.
Step 10. Reattach the rear cover, stand and stand cover.
Replacing a memory module
Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the rear cover.
To replace a memory module:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4.
Remove the rear cover. Refer to "Removing the rear cover".
Step 5.
Push out the latches on both sides of the memory socket to release the memory module. Gently
pull the memory module upward to remove it from its socket.
Step 6.
To install the new memory module:
a.
Align the new memory module with the memory socket, then insert it and push down on
the top edge.
b.
Make sure the latches lock the memory module in place.
.
Chapter 7
Replacing hardware
31
Hide quick links:
Advertisement
Table of Contents
