Replacing The Hard Disk Drive - Lenovo C20–00 Hardware Maintenance Manual

Step 12. Disconnect the LVDS cable to separate the rear cover from the front bezel.
Step 13. To reattach the rear cover:
a. Line up the rear cover with the front bezel and reconnect the LVDS cable.
b. Line up the holes on the rear cover with mounting holes on the front bezel, and place the rear
cover into position.
c. Secure the rear cover to the front bezel with the three screws.
d. Reattach the stand cover and the rubber cover.

Replacing the hard disk drive

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the rear cover.
To replace the hard disk drive:
Step 1. Remove any media (disks, CDs, DVDs or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4. Remove the rear cover. Refer to "Removing the rear cover".
.
Chapter 7 Replacing hardware
29