LG CRD-8161B Service Manual page 9

Table of Contents

6. Write I/F Signal Flow (Drive << Host)

Above figure is timing flow presented data transfer from Host to Drive.

And, the followings are those conditions;

1. When the Host write the ATAPI packet command-word

2. When the Host write the Data (ex, Mode select command) - word

3. When the Host write the task file registers - byte

Now, the corresponding register is chosen by control signal HCSO, HCSI, HA [2:0] and the Host write the

command (or Data) through the corresponding register.

To write some words (or bytes), the IOW (IO write signal) must be active - low, that is, the actual Data (HD

[15:0]) will be loaded by the synchronized IOW signal (active-low).

*IOCS16 : depends on the quantity of Data (word or byte), that is, if word, that signal was enabled.

*IORDY : depends on the transfer rate of Host.

7. Read I/F Signal Flow (Drive >> Host)

HA [2:0

]

HCS0, HCS1

IOR

HD [15:0]

IOCS16

IORDY

Above figure is timing flow presented data transfer from Drive to Host.

And, the followings are those conditions;

1. When the Host read the data from Drive (ex, Read command) - word

2. When the Host read the task file registers - byte

Above timing sequence is similar with the previous write timing sequence.

Only different thing is that the IOW is substituted by IOR (IO read signal)

that is, the actual data will be loaded by the synchronized IOR signal (active -low).

≈

Dn-3

Dn-2

Dn-1

≈

Dn-3

Dn-2

≈

Dn-1

Table of Contents