Location Of Customer Controls; Front View; Back View - LG CRD-8161B Service Manual

LOCATION OF CUSTOMER CONTROLS

FRONT

FRONT VIEW

1. Headphone Jack
3.5mm jack for monitoring the audio signal from audio
CDs.
2. Headphone Volume Control
Adjusts the headphone sound level.
3. Disc Slot
Push a 12cm CD-ROM disc into slot.
4. Busy Indicator
The Busy Indicator lights during initialization and data-
read operations.
REAR

BACK VIEW

1. Digital Audio Ouput Connector
This is a digital audio output connector or Video CD
output connector.
You can connect this to the digital audio system or
Video CD Board.
2. Analog Audio Output Connector
The Audio Output Connector connects to a sound
card.
The supplied audio cable is a SoundBlaster
cable. If you have a different sound card, you must
optain the proper for that card.
4
1 2
Figure 1. Front View
DIGITAL ANALOG
AUDIO AUDIO
D G R G L C S M 39
40
S L A
2
1 3
Figure 2. Back View
® type
3 4 5
5. Play/Skip Button
When an Audio CD is in the unit, pressing this button
will start playing audio CDs from the first track. If an
audio CD is playing, pressing this button will skip to
the next track.
6. STOP/EJECT Button
This button is pressed to eject the CD disc.
The button works only when power is applied to the
drive.
If an audio CD is playing, pressing this button will stop
it, and pressing it
INTERFACE
1
2
4
3. Master / Slave / CSEL Jumper
These three jumpers are used to set the CD-ROM
Drive to either a Master, Slave, or CSEL drive.
4. Interface Connector
This 40-pin connector is used to transfer and control
signals between the CD-ROM Drive and your PC.
Connect the 40-pin IDE cable in your PC to this
connector.
5. Power-in Connector
Attach a power cable from the computer to this
connector.
6
again will eject the CD disc.
POWER
+12
+5 GND
5