Xplore iX101B2 User Manual page 29

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B) / NMB-3 (B)
The device could automatically discontinue transmission in case of absence of information
to transmit, or operational failure. Note that this is not intended to prohibit transmission of
control or signaling information or the use of repetitive codes where required by the
technology. The device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems; the maximum
antenna gain permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to
comply with the e.i.r.p. limit; and The maximum antenna gain permitted (for devices in the
band 5725-5850 MHz) to comply with the e.i.r.p. limits specified for point-to-point and non-
point-to-point operation as appropriate, as stated in section A9.2(3). In addition, High-
power radars are allocated as primary users (meaning they have priority) of the band 5250-
5350 MHz and this radar could cause interference and/or damage to LE- LAN devices.
IC radiation exposure statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC
RSS-102 and had been tested in accordance with the measurement methods and
procedures specified in IEEE 1528.
RF Exposure Information (SAR)
This device meets the EU requirements (1999/519/EC) on the limitation of exposure of the
general public to electromagnetic fields by way of health protection.
Intel® Dual Band Wireless-AC 7265 Country-specific Compliance Statements
Hereby, Xplore Technologies declares that the Intel® Dual Band Wireless-AC 7265 complies
with the essential requirements and other relevant provisions of Directive 1999/5/EC. This
equipment is marked with the CE symbol and can be used throughout the European
community.
Sierra EM7355/7305 Country-specific Compliance Statements
Hereby, Xplore Technologies declares that the Sierra EM7355 complies with the essential
requirements and other relevant provisions of Directive 1999/5/EC. This equipment is
marked with the CE symbol and can be used throughout the European community.
Chapter 7 Agency Notes DOC (Industry Canada Notices) 25