Rf Exposure - Xplore iX101B2 User Manual

RF Exposure

Tests for SAR are conducted using standard operating positions specified
By the FCC with the tablet PC transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the tablet PC while operating can be well below the maximum value.
This is because the tablet PC is designed to operate at multiple power levels so as to use
only the power required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Before a tablet PC model is available for sale to the public, it must be tested and certified to
the FCC and IC that it does not exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in positions and locations (e.g., next
to body/lap) as required by the FCC for each model. (Next to body/lap measurements may
differ among tablet PC models, depending upon available accessories and FCC and IC
requirements). While there may be differences between the SAR levels of various tablet PCs
and at various positions, they are all required to meet the government regulations for safe
exposure.
This device was evaluated and shown to comply with FCC and IC SAR RF exposure
requirements.
Avoid covering or holding antennas when transmitting. Antenna locations are shown in the
following figure.
Antennas
Chapter 7 Agency Notes
WLAN
Bluetooth
Antenna
FCC Notices 22