Table of Contents
Advertisement
ASSEMBLY
Fig. 1
Fig. 3
ASSEMBLY
IMPORTANT: The dust cup filter must always be
in place when operating the hand vacuum.
1 Push the dust cup release button and remove the
dust cup. (fig. 1)
2 Verify that the dust cup filter is inside, then
reattach the dust cup to the hand vacuum. (fig. 2)
3 The motorized brush can be used to vacuum
short pile carpets or rugs. To attach the motorized
brush, make sure the On/Off switch is in the Off
position. Then firmly insert the motorized brush
into the air-intake nozzle, ensuring that the
contact pins are engaged in the connector slots of
the unit. (fig. 3)
WARNING: Do not touch the motorized brush
while it is in motion.
4 The crevice tool can be used to clean narrow, hard
to reach places. The dusting brush is used for the
furniture, venetian blinds, books, lamp shades and
shelves. Attach the desired attachment by pushing
it into the air-intake nozzle. (fig. 4)
6
0800 862 0453
Fig. 2
Fig. 4
Fig. 5
Fig. 6
UK plug
ASSEMBLING THE CHARGING BASE
1 Insert the charge adapter plug through the hole in
the underside of the charging base / wall mounting
bracket. (fig. 5)
2 Turn the charge adapter plug one quarter turn to
secure it into place. (fig. 5)
CHARGING BASE / WALL MOUNTING BRACKET
1 If you wish to mount the charging base onto a
wall, make sure that the intended wall area that
is to be drilled is free from any hidden electrical
wires, water pipes and gas lines.
2 Select an appropriate place that is close to an
electrical outlet. Do not mount near direct sunlight,
near a heat source or outdoors.
3 Select an appropriate drill type for the material to
be drilled.
4 Carefully measure and mark the location of all
bracket holes and then drill holes and screw the
charging base / wall mounting bracket onto the
wall. (Screws not included.) (fig. 6)
Advertisement
Table of Contents
