Packet Data Settings - Nokia N78 User Manual

receive data directly; a WLAN access point device is not
needed. In an ad hoc network, all devices must use the
same WLAN network
WLAN security mode
●
WEP, 802.1x (not for ad hoc networks), or
WPA2. If you select
used. The WEP, 802.1x, and WPA functions can be used
only if the network supports them.
To enter the settings for the selected security mode, select
WLAN security settings.
Security settings for WEP
WEP key in use — Select the wired equivalent privacy
●
(WEP) key number. You can create up to four WEP keys.
The same settings must be entered on the WLAN access
point device.
Authentication type
●
authentication type between your device and the
WLAN access point device.
WEP key settings — Enter
●
of the key), WEP key format (ASCII
and WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of authentication:
●
EAP to use an extensible authentication protocol (EAP)
plug-in, or Pre-shared key
Complete the appropriate settings:
© 2008 Nokia. All rights reserved.
name.
— Select the encryption used:
Open network, no encryption is
— Select Open or Shared
WEP encryption
or Hexadecimal),
to use a password.
EAP plug-in settings
●
service provider instructs.
Pre-shared key
●
password must be entered on the WLAN access point
WPA/ device.
WPA2 only mode
●
allowed to establish a connection in this mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
the subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these
addresses.
IPv6 settings
●
for the
Ad-hoc channel
●
channel number (1-11) manually, select
defined.
(length
Proxy server address
●
proxy server.
Proxy port number
●

Packet data settings

Press
Packet data.
— Enter the settings as your
— Enter a password. The same
— Only WPA2 enabled devices are
Advanced settings
>
— Enter the IP address of your device,
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for the
— Enter the proxy port number.
, and select Tools Settings
>
and from the
User
Connection
> >
149