TP-Link T2600G-28TS Installation Manual page 9

LED Status
On
Green
Flashing
10/100/
1000Mbps On
(Port 1-48)
Yellow
Flashing
Off
On
Link/Act
Flashing
(Port 49-52)
Off
Console (RJ-45) Port
Designed to connect with the serial port of a computer or terminal for monitoring
and configuring the switch.
Console (USB) Port
Designed to connect with the USB port of a computer for monitoring and configuring
the switch. The switch has an RJ-45 console port and a micro-USB console port
available. Console input is active on only one console port at a time. By default, the
micro-USB connector takes precedence over the RJ-45 connector.
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each 10/100/1000Mbps RJ45 port has a corresponding 1000Mbps LED.
SFP Port
Designed to install the SFP module. T2600G-52TS features 4 individual SFP ports
and supports 1000M SFP module connection only.
Port Feature
Model 10/100/1000Mbps RJ45 Port
T2600G-28TS
T2600G-52TS
Rear Panel
■
Due to the similarity of T2600G-28TS and T2600G-52TS in the rear panel, here
T2600G-28TS is used as an example.
Indication
A 1000Mbps device is linked to the corresponding port,
but no activity.
A 1000Mbps device is linked to the corresponding port
and data is being transmitted or received.
A 10/100Mbps device is linked to the corresponding
port, but no activity.
A 10/100Mbps device is linked to the corresponding port
and data is being transmitted or received.
No device is linked to the corresponding SFP port but
no activity.
There is a device linked to the corresponding port.
The corresponding SFP port is transmitting or receiving
data.
There is no device linked to the corresponding SFP port.
SFP Port
24 4
48 4
Gigabit L2 Managed Switch
Console Port
2
2
03
Introduction