Table of Contents
Advertisement
Installing and removing a port cover
An optional rear port cover is available for the computer.
To install the port cover:
1.
Thread the cables through the bottom hole on the port cover (1) and connect the cables to the
rear ports on the computer.
2.
Insert the hooks on the port cover into the slots on the rear of the chassis (2), and then slide the
cover to the right to secure it in place.
NOTE:
For security purposes, you can install an optional cable lock to the chassis that locks the
port cover and secures the computer. See
The port cover is secured in place by a retention lever just inside the port cover opening. To remove
the port cover, pull the lever back towards the port cover opening (1), and then slide the cover to the
left and off the computer (2).
16
Chapter 2 Hardware upgrades
Installing a security lock on page
17.
Advertisement
Table of Contents
