Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Beep Tone - Sony XR-C5109R Operating Instructions Manual

Changing the operative direction
The operative direction of controls is factory
preset as in the illustration below.
To increase
To decrease
If you need to mount the rotary commander
on the right side of the steering column, you
can reverse the controls operative direction.
Press (SEL) for two seconds while
pushing in the VOL control.
Adjusting the sound
characteristics
1
Select the item you want to adjust by
pressing (SEL) repeatedly.
VOL (volume) n BAS (bass) n TRE
(treble) n BAL (left-right) n
FAD (front-rear)
2
Adjust the selected item by pressing
either (+) or (–).
Adjust within three seconds after selecting.
(After three seconds the button will again
serve as the volume control button.)

Attenuating the sound

Press (ATT).
The "ATT" indication flashes.
To restore the previous volume level, press again.
Tip
The unit decreases the volume automatically when a
telephone call comes in (Telephone-ATT function).
Changing the sound and
beep tone
Boosting the bass sound — D-bass
You can enjoy clear and powerful bass sound.
The D-bass function boosts the low frequency
signal with a sharper curve than conventional
bass boost.
You can hear the bass line more clearly even if
the vocal volume remains the same. You can
emphasize and adjust the bass sound easily
with the D-BASS control. This effect is similar
to the one you get when you use an optional
subwoofer system.
Moreover, the Digital D-bass* function creates
even sharper and more powerful bass sounds
than Analog D-bass.
Digital D-bass
D-BASS 3
D-BASS 2
D-BASS 1
0dB
Frequency (Hz)
Adjusting the bass curve
Turn the D-BASS control to adjust the
bass level (1, 2 or 3).
"D-BASS"* appears in the display.
To cancel, turn the control to the OFF position.
* If the CD changer has the digital D-bass function,
"DIGITAL D-BASS" appears on the display during CD
playback.
Note
If the bass sound becomes distorted, adjust the D-BASS
control or volume button.
Attenuating the beep tone
Press (6) while pressing (SEL).
To obtain the beep tone again, press these
buttons again.
Note
If you connect an optional power amplifier to the LINE
OUT and do not use the built-in amplifier, the beep tone
will be disabled.
Analog D-bass
D-BASS 3
D-BASS 2
D-BASS 1
0dB
Frequency (Hz)
EN
13