Table of Contents
Advertisement
Analog outputs
The 885 is equipped with a volume controlled balanced (XLR) output, level
adjusted at the factory to match power amplifiers with a gain of 26dB. When you
connect an 852 or 855 amplifier, or any other power amplifier with a gain of
26dB, it will produce exactly the same voltage at the speaker outputs as the 885.
This is useful for bi-amping setups or when playing music in two rooms.
Speaker terminals
The speaker outputs on the 885 are in the form of terminal posts. These are for
use with cables terminated with spades or 4mm (banana) plugs.
Please remember: the 885 is a fully balanced amplifier! This means that both the
red and the black speaker terminals on each channel are connected directly to
an amplifier output. Never connect the black terminal to ground – this will
damage the power amplifier!
Power switch
The power switch fully disconnects the 885 from the AC mains supply.
SYSCOM
SYSCOM allows you to network several 800 Series components (link mode). It
provides central control of switch-on and the display functions. To use this
facility, you must be using the appropriate power amplifiers or CD/SACD player.
Please ensure that all system components are switched off before changing any
SYSCOM connections. Use only the SYSCOM cables supplied. Do not use any
other type of cable, as this could damage your equipment! If you need longer
SYSCOM cables, please contact Lindemann audiotechnik directly (see back page
for contact details) or your dealer. You will find a detailed description of all link
mode functions in the link mode section of this manual.
Pin 1: Ground
Pin 2: Signal +
Pin 3: Signal -
885 Integrated Power Amplifier
9
Advertisement
Table of Contents
