Symbols - jobmate 54-2877-4 Owner's Manual


BATTERY & CHARGER
SAFETY


Do not operate charger if it has
received a sharp blow, been dropped
or otherwise damaged in any way. Have
a qualified technician examine the
charger and repair it if necessary. Do
not disassemble the charger.

For best results, do not charge the
battery when the battery or air
temperature is below 10
o
above 40 C (105

Unplug the charger when not in use
and before cleaning or maintenance.

Do not abuse the cord. To reduce the
risk of damage to the electric cord or
plug, never carry the charger by the
cord or yank the cord to pull the plug.
Always grasp the plug and pull to
disconnect. Always keep the cord away
from heat, oil and sharp edges.

SYMBOLS

WARNING:
!
symbols may be used on your tool.
Please study them and learn their
meaning. Proper interpretation of these
symbols will allow you to operate the tool
better and safer.
V
volts
A
amperes
Hz
hertz
W
watts
Kw
kilowatts
microfarads
L
litres
o o
C (50 F) or
o
F).
Some of the following
SAVE THESE INSTRUCTIONS FOR REFERENCE
SYMBOLS
Kg
kilograms
2
Newton per square
N/cm
centimetre
Pa
Pascal
H
hours
Min
minutes
S
seconds
alternating current
three-phase alternating
current
three-phase alternating
current with neutral
direct current
no load speed
alternating or direct current
class ii construction
splash proof construction
watertight construction
protective earthing at
earthing terminal, class i
tools
revolutions, oscillations or
reciprocations per minute
diameter
off position
arrow
warning symbol
This symbol designates that this
tool is listed with both Canadian
and U.S. requirements by
Underwriters Laboratories.
7