Factory Mode - Toshiba TDP- T80 Service Manual

3-4

Factory Mode

Hot Keys to enter Factory Mode (T90 Series and S80 Series) (For TW90, it should have signal
input)
[Press Volume button, set value to 9 and press “On/Standby”, “Input” and “Setup” button
simultaneously.]
Repeat the above-mentioned procedure in the bracket three times.
Hot Keys to enter Factory Mode (MT200)
[Press the “ON/STANDBY” button and then press “Set up”, “Input” and “Up” (
simultaneously.]
Repeat the above-mentioned procedure in the bracket three times.
3-4.1 Keystone calibration menu (For TDP-T90 and S80)
(Press "INPUT" and "UP" button simultaneously to enter the keystone
calibration menu)
Note :
There should be values in keystone calibration menu; otherwise Auto keystone and Auto setting
will not function.
Key :
a.) Horizontal calibration
Requirement:
Procedure:
simultaneously
3-10
) buttons