Factory Osd - Toshiba TDP-D1 Service Manual

Special Key for TOSHIBA DLP Projector TDP-D1
The following keys are effective when inserting a power cord plug in a power socket. Press keys until the LED becomes standby mode.
Key1
ON/STANDBY
AUTO SET AUTO KEYSTONE
INPUT AUTO KEYSTONE
ON/STANDBY
The following keys are effective while displaying the volume menu.
Key1
AUTO SET AUTO KEYSTONE
The following keys are effective in the special (factory) mode.
Key1
AUTO KEYSTONE
AUTO KEYSTONE
AUTO KEYSTONE
AUTO KEYSTONE
INPUT
INPUT
INPUT
INPUT
ON/STANDBY
ON/STANDBY
ON/STANDBY
ON/STANDBY
The following keys are effective when inserting a power cord plug in a power socket. Press keys until the FlashUpgrader indicator begins to move.
Key1
AUTO SET AUTO KEYSTONE
*1 This operation method is opened to a user in the manual.
*2 This menu is displayed only when a screen size is FULL mode and an input source is RGB/YPbPr.
Chapter 7 Factory OSD
Key2
INPUT
AUTO SET
Key2
Key2
UP
DOWN
LEFT (VOL-)
RIGHT (VOL+)
UP
DOWN
LEFT (VOL-)
RIGHT (VOL+)
UP
DOWN
LEFT (VOL-)
RIGHT (VOL+)
Key2 FlashUpgrader
Waiting charactors Start firmware upgrade
ON/STANDBY
(VOL-) LEFT
AUTO
KEYSTONE
Key3
MENU Reset the user lamp time *1
MENU Go to the special (factory) mode
MENU Ignore the error detection
MENU Reserved
Key3
MENU Go to the special (factory) mode
Key3
- Display the lamp time menu
- Display the ADC level alignment menu *2
- Display the keystone calibration menu
- Display the color wheel delay menu
- Display the fan control menu
- Display the white peak menu
- Display the test pattern menu
- Display the video curtain & spoke light menu
- Display the burn in mode menu
- Display the RGB gain (DDP1000) menu
- Reserved
- Save the factory data, the lamp data and the error data
INPUT
UP
RIGHT (VOL+)
DOWN
AUTO
SET
Function
Function
Function
Function
MENU
Rev. F 2003.1.25
55