Front Handle Installation; U-Handle Installation - Echo SRM - 3100 Operator's Manual

FRONT HANDLE INSTALLATION

Tools Required: Screwdriver.
Parts Required: Front Handle Assembly
1. Position front handle on drive shaft, DO NOT tighten screws yet.
2. Position front handle for comfortable operation and secure screws.
-
U HANDLE INSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, Screwdriver.
Parts Required: SRM-3100 Series U-Handle Kit P/N 35130455730.
SRM-3400 Series U-Handle Kit P/N 35130455830.
NOTE
On model SRM-3110 use Steps 1, 11 through 16 only.
1. Close choke and remove air filter cover.
2. Disconnect two (2) ignition stop leads (C).
3. Remove inner throttle linkage from carburetor swivel (B).
4. Loosen nut (A) and remove throttle linkage from bracket.
G T
RASS RIMMER
O
PERATOR
/B C
RUSH UTTER
' M
S ANUAL
A
C
17
B