Table of Contents
Advertisement
Front (loop) handle installation
Install the handle so that it does not hide any of the safety decals.
1. Front (Loop) handle.
Position the handle in a comfortable operating position and tighten screws (M5 x 35).
The cutting attachment should be 5 - 7.5 cm above the ground and as level as possible.
Plastic shield installation
The cut off knife on the debris shield has sharp edges.
Avoid contact when installing or removing the line head.
Do not operate the trimmer without the shield in the correct position.
1. Shield.
2. Plastic sleeve.
6. Bolt.
7. Bearing housing.
1) Remove plastic sleeve from output shaft.
2) Remove wing nut, washer, and bolt.
3) Snap the shield over the bearing housing.
4) Install bolt, washer and wing nut.
Nylon line head installation
Stop the engine before handling the nylon line head.
1. Output shaft.
2. Fixing plate.
5. Nylon line head.
1) Rotate the output shaft until the holes in fixing plate and in bearing housing are aligned.
2) Insert locking tool through these holes.
3) Install nylon line head to output shaft rotating clockwise.
4) Remove locking tool.
Nylon line head
Type :
Thread : Right-handed 3/8 x 24 UNF
Adjusting nylon line
Use only flexible, non-metallic line recommended by ECHO.
Hit knob against the ground surface lightly.
Make sure there is no bystander within 15 m radius and pay enough attention to objects in
the surroundings before starting operation.
Do not rotate the cutting head at more than 10000 r/mim.
Do not hit the cutting head against hard foreign matters such as rocks, concrete, tree stub
and bottle etc.
When releasing nylon line from spool hit tap knob of spool against the ground surface lightly
at rotation speed lower than 4500 r/min.
Cut off knife on the shield adjusts cutting swath to 40 cm automatically by cutting nylon lines
evenly when attachment starts rotating.
When operating with less than maximum cutting swath (40 cm), cut two nylon lines in equal
lengths.
Assembling
CAUTION
2. Handle bracket.
3. Four screws (M5 x 35).
WARNING
CAUTION
3. Output shaft.
8. Cut off knife.
CAUTION
3. Bearing housing.
CAUTION
1. Tap knob.
13
4. Wing nut.
5. Washer.
4. Locking tool.
2. Nylon line comes out.
Hide quick links:
Advertisement
Table of Contents
