Selecting A Single Picture And Printing It; Selecting Multiple Pictures And Printing Them - Panasonic DMC-FX37 Operating Instructions Manual

2
Press 3/4 to select [PictBridge(PTP)], and then
press [MENU/SET].
Note
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
•
Turn the camera off before connecting or disconnecting the AC adaptor (DMW-AC5PP;
optional).
•
Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
•
You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
•
The pictures recorded in clipboard mode, copy them onto a card (P69), and then print them out.
1
Press 2/1 to select the picture and then press
[MENU/SET].
•
The message disappears in about 2 seconds.
2
Press 3 to select [PRINT START] and then press
[MENU/SET].
•
Refer to P92 for the items which can be set before starting to print
the pictures.
•
Press [MENU/SET] to cancel printing halfway.
•
Disconnect the USB connection cable after printing.
1 Press 3.
2
Press 3/4 to select an item and then press [MENU/
SET].
•
If the print check screen has appeared, select [YES], and print
the pictures.
Downloaded From camera-usermanual.com Panasonic Manuals

Selecting a single picture and printing it

Selecting multiple pictures and printing them

Connecting to other equipment
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT SET
PictBridge
100 _ 0001 100 _ 0001 100 _ 0001
100 0001
PLEASE SELECT
THE PICTURE TO PRINT
SELECT
MULTI PRINT PRINT
SINGLE SELECT
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
CANCEL SELECT SET
PictBridge
MULTI SELECT
SELECT ALL
DPOF PICTURE
FAVORITE
CANCEL SELECT
SET
VQT1R87
MENU
1/9 1/9 1/9 1/9
MENU
OFF
1
MENU
MENU
91