Selecting A Single Picture And Printing It - Panasonic Lumix DMCFX700EP Operating Instructions Manual

Note
•
This unit cannot stand upright when the AC adaptor is connected. When placing it on a surface
and operating it, we recommend placing it on a soft cloth.
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
•
Turn the camera off before connecting or disconnecting the AC adaptor (optional).
•
Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
•
You cannot switch between the built-in memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
•
Motion pictures recorded cannot be printed out.
Drag the screen horizontally to select an
image, and then touch [PRINT].
•
You can forward or rewind pictures continuously by
keeping your finger on the left or right sides of the
screen after forwarding/rewinding a picture.
(Pictures are displayed reduced in size)
•
The message disappears in about 2 seconds.
Touch [PRINT START].
•
Refer to P177
starting to print the pictures.
•
Touch [CANCEL] to cancel printing halfway.
•
Disconnect the USB connection cable after printing.
Connecting to other equipment

Selecting a single picture and printing it

for the items which can be set before
- 175 -
PictBridge PictBridge PictBridge
100 _ 0001 100 _ 0001 100 _ 0001
100 0001
1/7 1/7 1/7
MULTI PRINT
PRINT
SINGLE SELECT
PRINT START
PRINT WITH DATE
OFF
NUM.OF PRINTS 1
PAPER SIZE
PAGE LAYOUT
CANCEL