Spray Arms; Hose Filter - Gram DSI 6411-60 Instruction Manual

Spray arms

Hose filter

Water is prevented by the inlet hose filter so as to avoid any damage to your machine because
of any contamination (sand, clay, rust etc.) that might be occasionally carried in through the
mains water supply or the indoor plumbing, and to forestall such complaints as yellowing and
formation of deposits after washing. Check the filter and the hose from time to time and clean
them if necessary. To clean the filter, first turn off your tap and then remove the hose. After
removing the filter from the hose, clean it under the tap. Insert the cleaned filter back into its
place inside the hose. Refit the hose.
Check whether or not the holes for the
upper and lower spray arms are clogged. If
there is any clogging, remove the spray
arms and clean them under water.
You can remove the lower spray arm by
pulling it upwards, while the upper spray
arm nut can be removed by turning the nut
to the left.
Be sure that the nut is perfectly tightened
when refitting the upper spray arm.
28