Multiple Controller Installation - Russound MCA-66 Installation Manual

MULTIPLE CONTROLLER INSTALLATION

Linking Multiple Controllers
The RNET Link In and Link Out can be used to connect two or more (up to 6)
MCA-66 controllers. The connection is made using a CAT-5e patch cable from
the Link Out of the first controller and into the Link In of the next controller.
Along with RNET data signals, the RNET Link In and Link Out ports pass source
IR signals.
The CAT-5e patch cable must have an RJ-45 connector on each end with
T568A wiring configuration. It can not exceed 18 inches (45.7 cm) in length to
avoid potential cross-talk between the source-specific IR repeating signal lines.
NOTE: Use standard RCA Y-splitter cables to split audio between two
controllers. In some multicontroller systems, line level audio distribution amps
may be used. Ethernet connection to the LAN is only required on Controller #1
in a multi-controller system.
When using the BTC-1X Bluetooth on Source 1, connect the Source 1 OUT
on Controller 1 to the Source 1 IN on Controller 2. Continue the audio loop to
other controllers, if necessary.
MCA-66 Controller (ID#1)
CAT-5e Cable
MCA-66 Controller (ID#2)
Linked Controllers
14
Controller ID Switch Settings
The Controller ID switch is a rotary switch with six positions. It is used to set
the controller ID number for multiple controllers.
If two or more MCA-66 controllers are connected using the RNET Link In and
Link Out ports, each controller must have a unique controller ID prior to being
connected through the RNET ports. Set each controller's ID switch to a unique
number. Any multiple controller configuration requires that one controller be
set to controller ID #1. This action must be performed before the system setup
procedure is completed through SCS-C5 software and before powering up the
system. The small arrow on the dial should point at the desired setting.
Russound MCA-66 Installation Manual
Rotate switch to point arrow
to the intended position
DMS-3.1