Cleaning And Maintenance; Environmental Information - Power Craft 65400 Instruction Manual

INSTRUCTION MANUAL

Cleaning and maintenance

The saw can be cleaned by wiping its exterior parts
with a damp cloth. Ensure the ventilation slots are
kept free of dust and dirt.
Never use corrosive or abrasive cleaning agents, as
they may attack the plastic parts of the saw.
Always make sure the chain guide on the blade is
free of sawdust and bark splinters to ensure correct
lubrication. Use compressed air to keep the guide
clear. Remove the chain to clean the guide if it
cannot be cleaned satisfactorily with the chain on.
Sharpen the teeth using a chainsaw file or grinder.
Be very careful when sharpening the teeth! Replace
the chain when the teeth are worn down to the
mark.
Problem
Motor will not start
Chain will not revolve
Saw cutting ineffectively
Saw cutting ineffectively Chain
comes off blade
The chain gets very hot
ENGLISH
Fill the oil tank when the level is below the
minimum mark on the side of the tank.
Check for blade and sprocket wear and replace if
necessary.

Environmental information

You can help protect the environment!
Follow local environmental regulations:
Dispose of unwanted electrical
equipment at an approved refuse
disposal centre.
Possible cause
1. No electricity
2. Chain lock activated
3. Carbon brushes worn
Chain brake activated
1. Chain needs sharpening
2. Chain fitted incorrectly
3. Chain is loose
Chain is loose
Chain lubrication not working Check oil level and that the
Possible solution
1. Check cable, plug and plug
socket, and that a relay has
not tripped out.
2. Release chain brake
3. Replace brushes
Release chain brake
1. Sharpen chain
2. Fit chain correctly
3. Tighten chain
Tighten chain
automatic chain lubrication is
working
22