Advertisement
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on the
other side of the outlet box.
13
Raise the canopy up and align the two holes in
the canopy with the two holes in the hanger
bracket. Secure with two screws provided.
16
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. At-
tach blade assembly to motor using the motor
screws and washers provided. Tighten screws
securely.
© 2011 Monte Carlo Fan Company
11
House
Black
White
Green/
Green(Downrod)
Ground
Green(Bracket)
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground
wire. After wiring is conplete, gently push
wires into junction box with wire nuts pointing
upward. Refer to point 3 of safety tips.
14
Place blade onto blade holder.
17
Remove 1 screw and save.Loosen other 2
screws.
4
12
Fan
Blue
Black
White
For control of fan and optional light from wall lo-
cation, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
15
Install 3 screws and washers per blade and
tighten securely. Repeat for all 5 blades
18
Remove
and save
screws
Push wires through center hole.Line up 2 screws
loosened from step 17.
Wall
Control
1/16/2012
Advertisement
