Table of Contents
Advertisement
Setting up your projector (continued)
Front projection, ceiling mounting
For ceiling mounting,
you need the ceiling
mount kit designed
for this projector.
Ask a specialist for
installation. For details,
consult your dealer.
• The warranty on this projector does not cover any
damage caused by use of any non-recommended
ceiling mount kit or installation of the ceiling mount
kit in an improper location.
• When using the projector mounted on the ceiling,
set Location in the Projection menu to Front Ceiling.
(See page 36.)
• When the projector is mounted on the ceiling,
images may appear darker than those projected in
the case of tabletop mounting. This isn't a product
malfunction.
• Ask your installation specialist to provide an A/C
power switch. When you do not use the projector,
be sure to shut down the main power by the switch.
• Do not install the projector where the exhaust vents
are exposed to air emitted by an air conditioning.
Such installation may cause a breakdown.
• Do not install the projector near a fire alarm
because it emits hot air from its exhaust vents.
Rear projection
Ask a specialist for
installation. For details,
consult your dealer.
• For rear projection,
set Location in the
Projection menu to
Rear Tabletop. (See
page 36.)
Caution:
• Placing the projector directly on a carpet impairs
ventilation by the fans, causing damage or
failure. Put a hard board under the projector to
facilitate ventilation.
• Place the projector at least 50 cm (or 20 inch)
away from the wall to prevent the air inlet grille
and the air outlet grilles that emit hot air from
being blocked.
• Do not use the projector in the following locations
and manners, which may cause fire or electric
shock.
• In a dusty or humid place.
• In a sideways position, or with the lens facing
down.
• Near a heater.
• In an oily, smoky, or damp place such as a kitchen.
• In direct sunlight.
• Where the temperature rises high, such as in
a closed car.
• Where the temperature is lower than +41ºF
(or +5ºC) or higher than +95ºF (or +35ºC ).
Important:
• We don't recommend using the projector at an altitude
of 1500 meters or higher. Use at an altitude of 1500
meters or higher may affect the projector's life.
TRIGGER terminal
The TRIGGER terminal on the rear of the projector
is a terminal that outputs a 12 V signal to control an
externally connected device (electric screen) when
images are projected.
To use the TRIGGER terminal, set Trigger1 (Power)
or Trigger2 (Anamo) to On in the Setup menu. (The
factory default is Off. See page 38 for details.) Use the
following steps to change the setting.
With the Setup menu:
(See page 34 for menu setting.)
1. Display the Setup menu.
2. Select Trigger1 (Power) or Trigger2 (Anamo) by
pressing the p or q button.
3. Select On or Off by pressing the t or u button.
To cancel the menu:
4. Press the MENU button.
Caution:
• Do not use the signal output from the TRIGGER
terminal as a power for other devices.
• Do not link the TRIGGER terminal with an audio
terminal of other device because that device may
be damaged.
• The rated current for the TRIGGER terminal is
200 mA. If you use a current exceeding this rating,
a failure may occur.
• For information about electric screens, please
contact screen manufacturers.
EN-13
To TRIGGER 1
or TRIGGER 2
terminal
Tip (12 V)
To externally
(Ground 0 V)
connected device
Advertisement
Table of Contents
