Table of Contents
Advertisement
Replacing the lamp (continued)
To replace the lamp:
1. Turn off the main power switch and unplug the
power cord.
2. Loosen 2 screws (a) using a Phillips screwdriver (+)
and remove the rear side lamp cover (b) from the
projector.
3. Loosen 2 screws (c) using a Phillips screwdriver (+).
4. Pull the handle.
5. Pull out the lamp box by the handle while holding
the projector.
• Pull the lamp box out of the projector slowly.
If it is pulled out quickly, the lamp may break
scattering glass fragments.
• Do not spill liquid on the removed lamp box or do
not place it near any flammable object or where
children can reach to prevent injury or fire.
6. Load a new lamp box securely into the projector in
the right orientation.
(b)
(a)
(b)
(c)
7. Put the handle back to the original position.
• Make sure that the handle is locked.
8. Tighten up 2 screws (c) using a Phillips screwdriver
(+).
•
Make sure that the screws are tightened firmly.
9. Attach the rear side lamp cover (b) to the projector
and fix it with 2 screws (a).
•
Make sure that the screws are tightened firmly.
Reset of the lamp operation time
10. Plug the power cord into the wall outlet and turn on
the main power switch.
11. Display the Setup menu. (See page 34 for menu
setting)
12. Press the q button to select Lamp Time Reset.
13. Press the ENTER button to display the Confirm
selection.
14. Select Yes to confirm.
Important:
• Make sure the Lamp Hours(Normal) in Info. menu
reset back to 0 Hours.
• The projector doesn't turn on if the lamp cover isn't
attached securely.
• Be sure to reset the Lamp Hours(Normal) whenever
you replace the lamp.
• Do not reset the Lamp Hours(Normal) unless you
replace the lamp.
• The lamp is fragile. If it is broken, be careful not to
cut yourself with glass fragments.
Caution:
• This projector uses a lamp that
contains mercury. Disposal of the lamp
or the projector with the lamp may
be regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the Electronic
Industries Alliance: www.eiae.org. (For
the U.S. only.)
EN-45
(c)
(a)
(b)
Advertisement
Table of Contents
