Specifications - Makita 9207SPB Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Speed change switch
3-1. Side grip

SPECIFICATIONS

Max. capacities
Rated speed (n)/No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and paint.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
4-1. Wool bonnet
4-2. Lock nut
4-3. Rubber pad
7-1. Limit mark
Model
Wool bonnet
Spindle thread
)
0
Overall length
Net weight
Safety class
noise level determined
) : 86 dB(A)
pA
) : 97 dB(A)
WA
value (tri-axial vector
2
) : 5.0 m/s
h,P
2
ENE051-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
ENF002-2
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
ENG905-1
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible manufacturer
declare that the following Makita machine(s):
ENG900-1
Designation of Machine:
sum)
Polisher
Model No./ Type: 9207SPB
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
ENG902-1
standards or standardised documents:
EN60745
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
8-1. Screwdriver
8-2. Brush holder cap
9207SPB
180 mm
M14
-1
4,100 min
455 mm
3.4 kg
/II
ENH101-16