Removing The Stokke® Izi Go™ By Besafe; Removing And Refitting The Cover; Cleaning Instructions - Stokke iZi Go by BeSafe User Manual

Stokke® iZi Go™ by BeSafe®
16 UK/IE
5. Pull the harness strap through the central adjuster in the direction of the green arrow
straight up-/forward. Continue pulling until the harness is a comfortable but firm fit.
• Make sure that the harness straps are always locked and tightened when
the child is in the seat.
• You can protect your child against the sun by unfolding the sun canopy.
Baby cushion and body hugger configurations
<60cm (0-4 months) 60–65cm (4-6 months)
OK to use baby cushion REMOVE baby cushion
and body hugger
>65cm (6 months
and older)
REMOVE baby cushion
and body hugger
Stokke® iZi Go™ by BeSafe®
Removing the Stokke® iZi Go™ by BeSafe®
• Remove the shoulder belt from the shoulder belt hook at the rear side.
• Release the belt from the buckle in the car and remove the belt from the hip belt
hooks.

Removing and refitting the cover

Removing the cover
• Pay attention when you remove the cover, as fitting the cover is done in the
opposite way.
• Take off the headrest and the baby cushion.
• Open the zippers. Do not remove the harness straps from the hooks in the seat.
• Take off the complete cover by pulling it carefully from the foam.
Refit the cover
• Pull the harness straps through the openings in the cover and close the zippers.
• Pull the buckle through the crotch strap cover and pull the hole for the central
adjuster over the central adjuster.
• Fix the cover at all sides by putting it carefully between the foam and seat shell.

Cleaning instructions

The covers of the Stokke® iZi Go™ by BeSafe® must be washed in accordance with
the instructions on the inside of the covers. Clean harness by hand with water and
mild soap.
UK/IE 17