Stokke iZi Go by BeSafe User Manual page 3

Stokke® iZi Go™ by BeSafe®
4 UK/IE
WARNING
• It is important that you read this user manual BEFORE installing your seat. Incorrect
installation could endanger your child.
• KEEP this user manual with the seat for later use.
• It is NOT ALLOWED to mount the seat in a front passenger seat
WITH AN ACTIVATED AIRBAG.
• The seat can only be installed rearward-facing with a 3-point
car belt, approved according to UN/ECE Regulation No.16 or other equivalent
standards.
shoulder
OK
belt
hip belt
• Stokke® iZi Go™ by BeSafe® is approved for group 0+, rearward-facing from 0-13 kg.
• If the child weighs over 13 kg or his shoulder height reaches above the highest
position of the shoulder straps, you will need to change to a group 1 seat.
WARNING
NO
WARNING Stokke® iZi Go™ by BeSafe®
• The child must always be secured with the internal harness straps when seated
in the child seat. The same applies to carrying the seat and when using in
combination with a stroller.
• The seat cover contains magnets in the areas with the orange indications. Magnets
can influence electronic equipment such as pacemakers.
• The seat must always be replaced following an accident. Although it may look
undamaged, in the event of another accident, it might not be able to protect your
child as well as it should.
• Prevent the seat from becoming trapped or weighed down by luggage, seats and/
or slamming doors.
• Before every use, make sure the harness is not damaged or twisted.
• Make sure you can fit no more than one finger between the harness and your baby (1cm).
• Make sure the car safety belt buckle runs in a straight line and stays below the belt
hook of the seat.
UK/IE 5
WARNING