Removing And Refitting The Cover; Cleaning Instructions - Stokke iZi Go Modular User Manual

Using the Stokke® iZi Go Modular™ by Besafe® with a stroller from Stokke
The Stokke® iZi Go Modular™ by BeSafe® can only be used on the following strollers:
Stokke® Xplory®, Stokke® Crusi™, Stokke® Trailz™ and Stokke® Scoot™.
Installation on a stroller (19)
Align the stroller adapter house above the adapters of the stroller and move straight down,
click (2x) ! Green dots on both sides indicate that the seat is properly fastened.
• The car seat should always be facing the parent (20).
Removing from a stroller (21)
• Move the carrying handle into carrying position.
• Push the stroller release up at both sides while lifting the seat vertically from the stroller.

Removing and refitting the cover

• Do take care when you remove the cover, as re-fitting the cover is done in reverse.

Cleaning instructions

The covers of the Stokke® iZi Go Modular™ by BeSafe® must be washed in accordance with
the instructions on the inside of the covers. Clean harness by hand with water and mild soap.
Warning: potential misuse
• The child seat MUST NOT be installed in a front passenger seat
WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that the floor support
is fully pushed down.
• Make sure the indicators are green before you drive.
EN
14
Stokke® iZi Go Modular™ user guide