Increasing Speed While In Cruise Control; Decreasing Speed While In Cruise Control; Deactivating Cruise Control - Triumph XRX Owner's Handbook Manual

General Information
Increasing Speed while in Cruise
Control
To increase the speed, press and release
the RES/+ adjust button. Each press of
the button will increase the speed by
1 mph or 1 km/h. If the button is held, the
speed continuously increases in single
digit increments. When the desired
speed is shown in the display, release
the adjust button.
1
1. Display screen
While increasing the speed, the display
screen in the instruments will change to
SEt, and will show the new set speed.
The new set speed will flash until the
motorcycle has achieved the speed.
After four seconds the display screen
will change to the previous display.
Note:
• If riding up a steep incline and cruise
control is unable to maintain the set
speed, the instruments will change
to SEt, show the set speed and will
flash until the motorcycle
regained the speed.
56
An alternative way to increase the
speed in cruise control is to accelerate
to the desired speed using the throttle
grip and then press the SET/- adjust
button.
Decreasing Speed while in Cruise
Control
To decrease speed, press and release
the SET/- adjust button. Each press of
the button will decrease the speed by
1 mph or 1 km/h. If the button is held, the
speed will continuously decrease in
single digit increments.
While decreasing the speed, the display
screen in the instruments will change to
SEt and will show the new speed.
When the desired speed has been
achieved, release the adjust button.
After four seconds the display screen
will change to the previous display.

Deactivating Cruise Control

The cruise control can be deactivated by
one of the following methods:
• Roll the throttle twist grip fully
forward
• Press and release
button on the right hand switch
housing
• Pull the clutch lever
• Operate the front or rear brake
• Increase speed by using the throttle
grip for more than 60 seconds.
Provided the cruise control has not been
deactivated by turning the ignition
switch to the OFF position, the previous
set speed can be resumed by pressing
and releasing the RES/+ adjust button.
has
The motorcycle speed has to be between
30 to 100 mph (48 to 160 km/h) and in
th
4 gear or higher.
the ON/OFF