Using Your Carpet Glider - Shark S3501NZ Owner's Manual

Using Your Steam Mop - cont'd
3
3
For your comfort, you can adjust the height of the
mop. Just lift the latch on the tube 90 degrees to the
open position. Holding the handle, extend the tube
to the height that's right for you and then close the
latch to the locked position.
4
When one side of the cleaning pocket gets dirty, just
flip the mop head and you can quickly start using
the other side. Dirt can't hide on either side. Use the
cleaning pockets with the scrubbing strip to clean
very dirty areas.
IMPORTANT: Please wait 3-5 minutes for the
Steam Pocket Mop to cool off before switching the
mop head or the cleaning pockets.
6 CUSTOMER CARE - NZ: 0800 002 999
4
5
When the water tank is empty, the steam mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the outlet. Follow the instructions from page 4.
This goes for switching the mop heads or cleaning
pockets as well.
IMPORTANT: Never leave the steam mop with a
damp/wet cleaning pocket on any floor surface for
any amount of time as this may damage the floor.

Using Your Carpet Glider

The Steam Mop won't clean your carpeting or
area rugs. However, it's great for deodorising
and freshening.
THE CARPET GLIDER
1
The Carpet Glider can be used with the rectangle mop
head to lightly steam your carpet and area rugs. Just
place the mop head on top of the glider and move
back and forth across a section of the carpet. The
steam mop won't clean your carpeting or areas rugs,
but it's great for deodorising and freshening.
NOTE: Please note that the Steam Mop rests on top
of the carpet glider and it is not a fixed attachment.
Do not leave steam mop with carpet glider in one
stationary position for any period of time.
1
CUSTOMER CARE - AU: 1800 890 840 7