Double Insulation; Mains Plug Replacement - Black & Decker KC1261FC Manual

DOUBLE INSULATION

Your Black & Decker charger is double
insulated in accordance with EN60335.
REPLACEMENT OF THE SUPPLY CORD.
(AUSTRALIA/NEW ZEALAND)
If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or similarly
qualified person in order to avoid a hazard.

MAINS PLUG REPLACEMENT

(U.K. & IRELAND ONLY)
• Should your mains plug need replacing and you are
competent to do this, proceed as instructed below. If
you are in doubt, contact an authorised repair agent
or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged in
a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs fitted
with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked at
the connection points of most good quality plugs.
Attach the wires to their respective points in the
plug (see below). Brown is for Live (L) (2) and Blue is
for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N) wires
to the earth pin marked E or
USING AN EXTENSION CABLE
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger (see
technical data). The minimum conductor size is 0.5
2
mm ; the maximum length is 30 m.
KC1261/62/82FC ML p01-40 PM6.5
BATTERY PACK
The Battery pack of your drill is not charged when
supplied as new. A new Battery, or one that has not
been used for an extended period, achieves full
performance only after approximately 5 charging and
discharging cycles.
CHARGING YOUR CORDLESS DRILL
Before attempting to charge your drill, read all the
safety instructions.
To charge your drill, proceed as follows:-
Put the forward/reverse switch in the centre (lock-off)
position. Remove all accessories from the chuck. To
remove the battery pack, depress the two release
buttons and withdraw the battery pack. Plug the
charger into a standard 220/240V socket. Place the
pack in the charger.
While charging, your battery pack may hum and
become warm to touch; this is normal.
After normal use your battery pack should be fully
charged in 15 minutes. If your power pack has been
run down completely, it may take up to 30 minutes to be
fully charged.
To prolong your power packs life, avoid leaving it on
charge for more than 8 hours.
CHARGING INDICATION MODES
• Red charging indicator blinks.
This indicates that the battery is being charged.
• Red light remains on.
This indicates that the battery is fully charged.
(3 Amp)
• Red indicator flashes rapidly.
This indicates there is a fault. Remove battery from
charger and reinsert. If this fails try a new pack. If
your new pack also refuses to charge, have your
charger tested by an authorised repair agent.
• Red indicator blinks twice.
This indicates a temporary problem with the power
source; switch off supply and repeat charging process.
.
5
ENGLISH
Do not charge the battery pack at ambient
temperatures < 4°C or > 40°C. Recommended
charging temperature 24°C/74°F.
11-12-2000, 09:56
5