Cleaning And Maintenance; Electrical Safety - Black & Decker NV1200AV Manual

ENGLISH
These include:
Injuries caused by touching any mov-
u
ing parts.
Injuries caused by touching any hot
u
parts.
Injuries caused when changing any
u
parts or accessories.
Injuries caused by prolonged use of
u
the appliance. When using any appli-
ance for prolonged periods ensure you
take regular breaks.

Electrical safety

The appliance is designed for use with
12V negative ground vehicle battery
systems.
Warning! The cigarette lighter connec-
tor is fitted with a non-serviceable safety
fuse. The fuse may operate in the event
of a fault. If this occurs the fuse must be
replaced together with the connector and
cable by the manufacturer or an author-
ised BLACK+DECKER Service Centre in
order to avoid a hazard.
Warning! Do not operate the appliance
with systems which have positive ground
or a different voltage.
Features
This appliance includes some or all of the following features.
1. On / Off switch
2. Release button
3. Dust bowl
4. Cigarette lighter connector
5. Brush tool
6. Small Crevice tool
7. Large Crevice tool
8. Hose
9. Right angle brush
10. Hose connector
4
(Original instructions)
Assembly
Mounting accessories (fig. B)
To fit an accessory proceed as follows:
Insert the appropriate accessory into the front of the
u
appliance
Use
Connecting to the vehicle's power
supply
Make sure that the appliance is switched off.
u
Remove the cigarette lighter from it's socket.
u
Plug the connector (4) into the cigarette lighter socket.
u
Switching on and off (fig. A)
To switch on, slide the on/off switch (1) forward.
u
To switch off, slide the on/off switch (1) backward
u
The appliance can be used for periods of up to 30 minutes
without noticeably affecting the power of a normally charged
car battery in good condition.
Warning! Extended use will drain the battery power. Do not
run the vehicle's engine while cleaning as this can shorten the
life of the appliance.

Cleaning and maintenance

Cleaning the dust bowl and filters
(fig. C & D)
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper care
and regular cleaning.
Press the release button (2) and remove the dust bowl (3).
u
Empty the dust bowl.
u
Remove the pre-filter (11) by twisting clockwise.
u
Wash the filter in warm soapy water. The bowl can be
u
washed if necessary. Do not immerse the appliance in
water.
Make sure the dust bowl and filters are dry.
u
Refit the filters (11) onto the appliance twisting them
u
counterclockwise until they lock into place.
Refit the dust bowl onto the appliance. Make sure the dust
u
bowl clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean filters
and an empty dust bowl.