Cleaning And Maintenance - Black & Decker WV6015 Original Instructions Manual

Assembly
Fitting the accessories (fig. A & C)
These models are supplied with the
following accessories:
- a crevice tool (6) for confined
spaces
- a wet pick-up accessory (7) for wet
spills
To fit an accessory, proceed as follows:
Take the accessories from the

appliance.
Insert the appropriate accessory into

the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the
implementation of safety devices, certain
residual risks cannot be avoided. These
include:
Injuries caused by touching any

rotating/moving parts.
Injuries caused when changing any

parts, blades or accessories.
Injuries caused by prolonged use of

a tool. When using any tool for
prolonged periods make sure you
take regular breaks.
Impairment of hearing.

Health hazards caused by breathing

dust developed when using your tool
(example:- working with wood,
especially oak, beech and MDF).
Use
Before first use, the battery must be

charged for at least 24 hours.
Place the appliance on the charging

base whenever it is not in use.
Charging the battery (fig. D)
Make sure that the appliance is

switched off. The battery will not be
ENGLISH
charged with the on/off switch in the
on position.
Place the appliance on the charging

base as shown.
Plug in the charger. Switch on at the

mains.
Leave the appliance to charge for at

least 24 hours.
Whilst charging, the charger may

become warm. This is normal and
does not indicate a problem. The
appliance can be left connected to
the charger indefinitely.
Warning! Do not charge the battery at
ambient temperatures below 10°C or
above 40°C.
Switching on and off (fig. E)
To switch the appliance on, slide the

on/off switch (1) forward.
To switch the appliance off, slide the

on/off switch back.
Wet pick-up (fig. A)
Use the wet pick-up accessory (7) on
non-absorbent surfaces.
For best results when using this
accessory, hold the appliance at an angle
of 45° and pull it slowly towards you. On
absorbent surfaces, such as carpet, your
appliance will pick up wet spills better
without the accessory.
Emptying the dust bowl (fig. F & G)
Press the release button (2) and

remove the dust bowl (3).
Remove the filters (8 & 9).

Empty the dust bowl.

Refit the filters.

Refit the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place.

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters (fig.
F & G)
The filters are re-usable and should be
cleaned regularly.
Empty the dust bowl as described

above.
7